Aprilaire 1700 Guía para resolver problemas

Safety and Installation InstructionsModel 1700DehumidifierREAD COMPLETE INSTALLATION INSTRUCTIONS BEFORE STARTING. SAVE THIS MANUAL.

10WIRINGWIRE DEHUMIDIFIER TO HVAC EQUIPMENT• Six wires are required to connect the dehumidifier to the HVAC equipment. See Figure 10.• Connect wires f

11OPTIONAL VENTILATION – DAMPER AND OUTDOOR TEMPERATURE SENSOR• The Aprilaire®Normally-Closed Damper (Model 6506) needs to beinstalled in the outside

12CONTROL AND SETUPADJUSTING THE DEHUMIDIFIER SET POINTUse the main control knob (Figure 13) on the outside of the dehumidifierto set the dryness sett

13SETTING THE AIR CYCLING TIME• The “CYCLE TIME” potentiometer on the control (Figure 15) is used to set the cycletime within the period you set in th

14TROUBLESHOOTING GUIDESYMPTOM TROUBLESHOOTING PROCEDUREHVAC blower does not turn onwhen cycle time potentiometer is in “TEST” mode• Make sure there i

P.O. BOX 1467 • MADISON, WI 53701-1467 • PHONE: 800/334-6011 • FAX: 608/257-4357 • www.aprilairecontractor.com10006238B2203431

2SAFETY INSTRUCTIONSSPECIFICATION OVERVIEWWARNING1. 120 volts may cause serious injury from electricshock. Disconnect electrical power before starting

3WHOLE-HOUSE DEHUMIDIFIER OPERATION AND INSTALLATIONSIn this configuration, the dehumidifier will pull air from the principle living space or the retu

4WHOLE-HOUSE, RETURN TO SUPPLY3' MINCONDENSATE HOSE(TO COMMON DRAIN)VENTILATION (OUTSIDE AIR)CONTROL DAMPER (OPTIONAL)RETURN DUCTDEHUMIDIFIER CON

5This installation is used to dehumidify awhole house and also a separate conditionedspace like a finished basement. Two dampersare installed, one nor

6This installation is used todehumidify a whole house andalso a separate unconditionedspace like an unfinishedbasement or an area wherecirculation of

7LOCATIONThe dehumidifier can be installed in a wide variety of locations. It is required to be sheltered from theelements, but can operate in 40°F to

8DUCTINGINSTALLING DUCT COLLARSThe Aprilaire®Dehumidifier is supplied with two, 8” round collars for connecting to the inlet and outlet of the dehumid

9After determining the manner or type of dehumidification system configuration that will be used, and if the duct system equivalentlength is acceptabl